Message Seller: Bryan (Machine Shop in USA)

Used TORMACH PCNC1100 Vertical Machining Center

Pre-owned TORMACH PCNC1100 2012 Vertical Machining Center for only $12,900. This Vertical Machining Center has average cutting time and is equipped with a CNC control. This CNC Machine is currently located in MI. This TORMACH Vertical Machining Center is the only one in stock and available for a limited time. Get a quote today on this PCNC1100 before it's gone.

X Axis Travel: 18"
Y Axis Travel: 9.5"
Z Axis Travel: 16.25"
Rapid Rate X Axis: 110 IPM
Rapid Rate Y Axis: 110 IPM
Rapid Rate Z Axis: 90 IPM
Table Size: 34" x 9.5
Max Table Load: 500 LBS
Spindle Motor: 1.5 HP
Spindle Speed: 5,140 RPM
Spindle Taper: 30 CT
Dimensions: 56" x 45" x 60"
Weight: 1.300 LBS

• Flood Coolant
• Fog buster
• Power draw bar
• 4th axis
• Tail stock
• 4th axis fixture plate
• 3 jaw chuck
• 4 jaw chuck
• WIFI adapter
• .75" Shear Hog with spare inserts
• 1.5" shell mill with spare inserts
• Superfly with spare inserts
• Diamond drag engraver
• 2 5" tormach vises with assorted jaws
• Assorted er20 collets
• 15 TTS er20 tool holders
• TTS drill chucks
• Assorted TTS set screw mill holders
• TTS tightening fixture with er20 wrench
• Tapping head
• 2 tooling racks Spare Parts
• Fuses
• Spindle bearings
• R8 collets
• Coolant pump
• 2 stepper drives
• Control board
• Limit switches
• Draw bar spring washers
Bryan (Machine Shop in USA)
q-a icon
what did it cost when it was new?
close to $30,000
when do you need it out by?
No hard date, we just don't use it anymore and are looking to free up the space and capital.
what are the hours?
I'm not sure on the hours. Over its life it probably averages out to maybe 15 hours a week if that. So, probably under 6000 hours
any mechanical or electrical Issues?
Everything works both mechanically and electrically.

This deal went awesome, I'm super impressed!

End of Lease Manager

US Bank