Message Seller: Val (Machine Shop in USA)

Used ENSHU JE60 Horizontal Machining Center

Pre-owned ENSHU JE60 1999 Horizontal Machining Center for only $39,500 $34,500. This Horizontal Machining Center has average cutting time and is equipped with a YASNAC I80M controller control. This CNC Machine is currently located in MT. This ENSHU Horizontal Machining Center is the only one in stock and available for a limited time. Get a quote today on this JE60 before it's gone.

X Axis Travel: 23.6"
Y Axis Travel: 23.6"
Z Axis Travel: 23.6"
Rapid Rate X Axis: 1,181 IPM
Rapid Rate Y Axis: 1,181 IPM
Rapid Rate Z Axis: 1,181 IPM
Pallet Size: 15.75" x 15.75""
Max Pallet Load: 880 LBS
Spindle Speed: 8,000 RPM
Spindle Motor: 15 HP
Spindle Taper: 40 CT
Tool Changer: 40 ATC
cooler jacket for the spindle.
Spindle bearing diameter of 3.35”
Spindle is dual contact “Big Plus” Cat 40.
Does require specific pull studs on tools.
39+1 tool carousel.
Max tool diameter of 3.1”/5.71” w/ adjacent pockets empty.
Max tool length 7.9”
Max tool weight 6.6 lbs.
Tool to tool change time 1 sec
Chip to Chip 3 seconds.
Spindle ramp up time of 1.5 seconds.
Oversized 1.772” double pretensioned ball screws.

Dimensions: 91" x 143" x 109"
Weight: 19,840 LBS
Equipped With:
YASNAC I80M controller
Val (Machine Shop in USA)
q-a icon
any options?
Has overhead coolant, coolant ring around spindle, coolant bed washes into the auger, and through spindle coolant (I think it’s a low pressure in the 300-500 PSI range) 80 gallon tank. Chip auger that displaces chips onto a large tray above tank.
any mechanical or electrical Issues?
Spindle is completely rebuilt within the past 2 years. Less than 100 hours on spindle since rebuild. Brand new bearings, chromed and reground taper, seals, ect. Has a oil cooler jacket for the spindle.
what city and state is this machine located in?
Mozeman, MT

This deal went awesome, I'm super impressed!

End of Lease Manager

US Bank