Used HAAS DT2 Vertical Machining Center
Pre-owned HAAS DT2 2017 Vertical Machining Center. This Vertical Machining Center has average cutting time and is equipped with a Haas CNC Control control. This CNC Machine is currently located in Florida. This HAAS Vertical Machining Center is available for a limited time. Get a quote today on this DT2 before it's gone.
Specs:
X Axis Travel: 28"
Y Axis Travel: 16"
Z Axis Travel: 15.5"
Rapid Rate X Axis: 2,400 IPM
Rapid Rate Y Axis: 2,400 IPM
Rapid Rate Z Axis: 2,400 IPM
Table Size: 34" x 15"
Max Table Load: 250 LBS
Spindle Motor: 15 HP
Spindle Speed: 20,000 RPM
Spindle Taper: 30 CT
Tool Changer: 20 ATC
Drive System Inline Direct-Drive
Max Torque 16 ft-lb @ 2800 rpm
Max Tapping Speed 5000 rpm
Max Tap Size (aluminum) 1/2"–13
Max Cutting 1200 ipm
Chip to Chip 1.8 sec
Dimensions: 107" x 82" x 98"
Weight: 5,400 LBS
Y Axis Travel: 16"
Z Axis Travel: 15.5"
Rapid Rate X Axis: 2,400 IPM
Rapid Rate Y Axis: 2,400 IPM
Rapid Rate Z Axis: 2,400 IPM
Table Size: 34" x 15"
Max Table Load: 250 LBS
Spindle Motor: 15 HP
Spindle Speed: 20,000 RPM
Spindle Taper: 30 CT
Tool Changer: 20 ATC
Drive System Inline Direct-Drive
Max Torque 16 ft-lb @ 2800 rpm
Max Tapping Speed 5000 rpm
Max Tap Size (aluminum) 1/2"–13
Max Cutting 1200 ipm
Chip to Chip 1.8 sec
Dimensions: 107" x 82" x 98"
Weight: 5,400 LBS
Options:
Haas CNC Control
Probe
Programmable Coolant
4th Axis Ready
Chip Auger
Rear Chip Lift Auger with Standard Auger system
High Speed Machining
Probe
Programmable Coolant
4th Axis Ready
Chip Auger
Rear Chip Lift Auger with Standard Auger system
High Speed Machining
Owner:
Matt (Machine Shop in USA)
